Adjustments And Settings; Stitch Length; Cutting Width - JUKI MO-2800 Manuel D'instructions

Adjustments and settings

A
A
13

Stitch length

It can be adjusted while sewing.
The stitch length is infinitely variable from 0.7 to 4 mm. Most over-
lock work is done with a basic setting of 2.5 mm.
For roll hemming or narrow overlocking, it is best to set the dial at "0.7
to 1.5".
For blind stitch which requires the "use of separately-available
presser foot", set the dial at "4".
注意
Left needle Right needle
Upper knife
Fabric
Lower knife
Scale marks on the cutting width
adjusting dial
Left needle
and cloth
Right
cutting
needle and
width (mm)
cloth cutting
width (mm)
B
8
A

Cutting width

CAUTION
• Raise the upper knife.
• Turn cutting width adjustment dial in the desired direc-
tion.
• Lower upper knife.
The position of the lower knife determines the width of the
seam.
Reduce the cutting width if the edges of fine fabric curl up
when being sewn (A).
Increase the cutting width if the loops seem to be too
loose (B).
WARNING
Do not carry out sewing with a marking pin
stuck in the material. In addition, do not
attempt to cut anything other than fabric and
thread with the upper/lower knives. Be aware
that doing so can cause needle break or per-
sonal injury.
Switch the machine off (Power
switch to "0")
8