Installation And Connections - Alpine PKG-RSE3HDMI Guide D'installation

Installation and Connections

Before installing or connecting the unit, please read the
following thoroughly for proper use.
Warning
MAKE THE CORRECT CONNECTIONS.
Failure to make the proper connections may result in fire or
product damage.
USE ONLY IN CARS WITH A 12 VOLT NEGATIVE GROUND.
(check with your dealer if you are not sure.) Failure to do so may
result in fire, etc.
BEFORE WIRING, DISCONNECT THE CABLE FROM THE
NEGATIVE BATTERY TERMINAL.
Failure to do so may result in electric shock or injury due to
electrical shorts.
DO NOT ALLOW CABLES TO BECOME ENTANGLED IN
SURROUNDING OBJECTS.
arrange wiring and cables in compliance with the manual to
prevent obstructions when driving. cables or wiring that obstruct
or hang up on places such as the steering wheel, gear lever, brake
pedals, etc., can be extremely hazardous.
DO NOT SPLICE INTO ELECTRICAL CABLES.
never cut away cable insulation to supply power to other
equipment. doing so will exceed the current carrying capacity of
the wire and result in fire or electric shock.
DO NOT DAMAGE PIPE OR WIRING WHEN DRILLING
HOLES.
When drilling holes in the chassis for installation, take
precautions so as not to contact, damage or obstruct pipes, fuel
lines, tanks or electrical wiring. Failure to take such precautions
may result in fire.
DO NOT USE BOLTS OR NUTS IN THE BRAKE OR
STEERING SYSTEMS TO MAKE GROUND CONNECTIONS.
Bolts or nuts used for the brake or steering systems (or any
other safety-related system), or tanks should neVeR be used
for installations or ground connections. using such parts could
disable control of the vehicle and cause fire, etc.
KEEP SMALL OBJECTS SUCH AS BATTERIES OUT OF THE
REACH OF CHILDREN.
swallowing them may result in serious injury. if swallowed,
consult a physician immediately.
DO NOT INSTALL IN LOCATIONS WHICH MIGHT HINDER
VEHICLE OPERATION, SUCH AS THE STEERING WHEEL
OR SHIFT LEVER.
doing so may obstruct forward vision or hamper movement, etc.,
and result in a serious accident.
CAUTION
CAUTION-Laser radiation when open, DO NOT STARE INTO BEAM
2
-EN
Caution
HAVE THE WIRING AND INSTALLATION DONE BY
EXPERTS.
the wiring and installation of this unit requires special technical
skill and experience. to ensure safety, always contact the dealer
where you purchased this product to have the work done.
USE SPECIFIED ACCESSORY PARTS AND INSTALL THEM
SECURELY.
Be sure to use only the specified accessory parts. use of other
than designated parts may damage this unit internally or may not
securely install the unit in place. this may cause parts to become
loose resulting in hazards or product failure.
ARRANGE THE WIRING SO IT IS NOT CRIMPED OR
PINCHED BY A SHARP METAL EDGE.
Route the cables and wiring away from moving parts (like the seat
rails) or sharp or pointed edges. this will prevent crimping and
damage to the wiring. if wiring passes through a hole in metal,
use a rubber grommet to prevent the wires insulation from being
cut by the metal edge of the hole.
DO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE
OR DUST.
avoid installing the unit in locations with high incidence of
moisture or dust. Moisture or dust that penetrates into this unit
may result in product failure.
Precautions
Be sure to disconnect the cable from the (–) battery post before
•
installing your PKG-Rse3HdMi. this will reduce any chance
of damage to the unit in case of a short-circuit.
• Be sure to connect the color coded leads according to
the diagram. incorrect connections may cause the unit to
malfunction or damage to the vehicle's electrical system.
When making connections to the vehicle's electrical system,
•
be aware of the factory installed components (e.g. on-board
computer). do not tap into these leads to provide power for
this unit. When connecting the PKG-Rse3HdMi to the fuse
box, make sure the fuse for the intended circuit of the PKG-
Rse3HdMi has the appropriate amperage. Failure to do so
may result in damage to the unit and/or the vehicle. When in
doubt, consult your alPine dealer.
• the PKG-Rse3HdMi uses female Rca-type jacks for
connection to other units (e.g. aV head unit) having Rca
connectors. You may need an adaptor to connect other units.
if so, please contact your authorized alPine dealer for
assistance.
IMPORTANT
Please record the serial number of your unit in the space
provided below and keep it as a permanent record. the serial
number plate is located on the bottom of the unit.
SERIAL NUMBER:
INSTALLATION DATE:
INSTALLATION TECHNICIAN:
PLACE OF PURCHASE: