Batavia MAXXPACK BT-CCS004 Mode D'emploi page 15

Mini scie circulaire sans fil
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

filter out dust produced during the
respective application. If you are
exposed to excessive noise, you could
suffer hearing loss.
k. Make sure that other persons are at a
safe distance to your work area. Anyone
entering the work area must wear per-
sonal protective gear. Fragments of the
work piece or broken fitted tools could be
projected and inflict injury both within and
outside of the direct work area.
l.
Only hold the device by the insulated
gripping surfaces when performing an
operation where the fitted tool may
come into contact with hidden power
lines or its own mains cord. A cutting
accessory contacting a "live" wire may
make exposed metal parts of the power
tool "live" and could give the operator an
electric shock.
m. Never set the power tool down before
the fitted tool has come to a complete
stop. The rotating fitted tool could
come into contact with the surface of
the base and you could lose control of
the power tool.
n. Never allow the power tool to run while
you are carrying it. Your clothing could
accidentally come into contact with the
rotating fitted tool and the fitted tool
could be driven into your body.
o. Clean the vents of your power tool
regularly. The motor fan will draw dust
into the housing; if a large amount of
metal dust accumulates, it could pose
electrical hazards.
p. Do not store the power tool near flam-
mable materials. Sparks could ignite
these materials.
q. Do not use any fitted tools that require
liquid coolants. Using water or other
liquid coolants could cause an electrical
shock.
Safety instructions for handling
3.4.
saw blades
a. Only use fitted tools if you are able to
use them in a controlled manner.
b. Observe the maximum speed. The
maximum speed specified on the fitted
tool must not be exceeded. Only use
fitted tools whose specified maximum
speed is larger than the max. speed of
the product.
c.
Do not use any fitted tools that are
cracked. Dispose of any cracked fitted
tools. It is not permissible to repair
them.
d. Clean any dirt, oil, grease and water off
of the clamping surfaces.
e.
It is not permitted to use loose reducing
rings or bushings to reduce bore holes
in circular saw blades.
f.
Make sure that fixed reducing rings for
securing the fitted tool have the same
diameter and are at least ¹⁄₃ of the cut-
ting diameter.
g. Make sure that fixed reducing rings are
parallel to one another.
h. Handle the fitted tools carefully. Ideally,
you should store them in the original
packaging or special containers. Wear
protective gloves for better grip and to
further reduce the risk of injury.
i.
Before using fitted tools, make sure that
all protective devices are properly
secured.
j.
Before use, make sure that the fitted
tool complies with the technical require-
ments of this power tool and that it is
properly secured.
k.
Only use the enclosed saw blade for
cutting wood and never use it to cut
metals.
Safety instructions for diamond
3.5.
cutting discs
Use
Only use the cutting-off wheels for cut-off
grinding and not for rough grinding. Only
use the cutting-off wheels for the specified
material and not for other materials.
There is a risk of injury! Cut and then let the
material cool down afterwards.
General information
This fitted tool is susceptible to breakage
and therefore must be handled very care-
fully. Using damaged fitted tools or fitted
tools that are incorrectly clamped in place
English
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

7064048

Table des Matières