Clearing A Program; Write And Store New Program; Control By Core Temperature (Option); Setting The Starting Time Preselection - Salvis FS 1/1 P Instructions D'installation Et Mode D'emploi

6.10 Clearing a program

P program to be cleared (deleted).
Press P and enter program number
Clear the program with the following key combination:
C M
program no.

6.11 Write and store new program

To switch on the appliance, press
LED's P and are blinking.
Press P , the display shows the program number last
entered.
Press P , is blinking.
Enter a non occupied program number (refer to program
register), for example
An empty program number can be displayed by pressing
M 0
and together.
Programming phase 1:
Press , appears.
1 - 3
Press , enter value, e.g.
Press , enter value, e.g.
Press to save your selection.
Programming phases 2 and 3:
Press twice, appears
1 - 3
Press twice, appears
1 - 3
Program the two phases analoguos the first one.
To store the program press
Enter program number
Press to save the program.

6.12 Control by core temperature (Option)

- Insert core temperature sensor into the middle of the
food. Lock the door.
P Select a program or
Select oven temperature
Select core temperature 20 - 100°C
Start process
- Timer is inoperable
- After the set temperature is reached, the buzzer
sounds or the process jumps to the next phase.
- If the sensor is not inserted into the food, the sensor
temperature rises too quickly. An operating error 12 is
displayed. The buzzer sounds until cancelled.
- If one wishes to increase the core temperature after it
is reached, a temperature difference of at least +3°C is
necessary.

6.13 Setting the starting time preselection

Enter the desired cooking program
Press ; LED blinks.
.
.
.
.
M
, is blinking.
.
P
.
The last entry is displayed.
Press ; LED blinks.
The display shows
Enter on the numeric keyboard.
Press to save your entry.
Press start . All displays go out.
The appliance will automatically start at the set time
.
When the cooking program has finished the buzzer
sounds. To activate the display light and show the clock,
press .
To return to the starting time preselection mode, press
the keys and
To show the actual time and the program number, press
the key . .

6.14 Setting the clock, date and year

For setting, the appliance must be in switched on state.
Either P is blinking
or the LED's and
Setting the clock:
Press and enter the time in hours and minutes
, using the point
Confirm by pressing
Setting the date:
Press , then
Enter day and month
as a separator.
Confirm by pressing
Setting the year:
Press , then
Enter year
Confirm by pressing
Press again to return to the clock.
Note: After a longer period of disconnection of the
appliance the clock has to be readjusted.

6.15 Regenerating

- When the display shows
processes can be started, depending on the water
credit.
- When the display shows
will need to be regenerated.
- Normal operation is now blocked and no new cooking
process can be started. Check that the current
cooking process has been fully completed before you
start regeneration.
- 36 -
.
.
P are blinking.
.
as a separator.
, using the point
.
, further cooking
, the appliance
.