Changing The V.34 Setting; To Change The V.34 Setting - HP LaserJet 3015 Mode D'emploi

Changing the V.34 setting

The V.34 setting is the modem protocol that the device uses to send faxes. It is the
worldwide standard for full-duplex modems that send and receive data across telephone
lines at up to 33,600 bits per second (bps). The factory-set default for the V.34 setting is On.
You should change the V.34 setting only if you are having trouble sending or receiving a fax
from a particular device. Turning off the setting might be useful when you are trying to send
a fax overseas, or receive one from overseas, or if you are using a satellite telephone
connection.

To change the V.34 setting

1. Press
2. Use the
3. Use the
4. Use the
5. Use the
66 Chapter 3 Faxing (advanced)
/ .
MENU ENTER
< or the > button to select Fax setup, and then press
< or the > button to select All faxes, and then press
< or the > button to select V.34, and then press
< or the > button to select On or Off, and then press
/ .
MENU ENTER
/ .
MENU ENTER
/ .
MENU ENTER
/ .
MENU ENTER
ENWW