Setting The Answer Mode; To Set The Answer Mode - HP LaserJet 3015 Mode D'emploi

Setting the answer mode

Depending on your situation, you can set the device answer mode to Automatic or Manual.
The factory-set default is Automatic.
● Automatic: In this answer mode, the device answers incoming calls after a specified
number of rings or upon recognition of special fax tones. To specify the number of rings,
see
● Manual: In this answer mode, the device never answers calls. You must start the fax-
receiving process yourself, either by pressing
up a telephone that is connected to that line and dialing 1-2-3 (in tone-dial mode only).
Although most users leave the answer mode set to Automatic, voice callers who dial the fax
Note
telephone number will hear fax tones if the telephone is not answered, or if they do not hang
up by the specified number of rings-to-answer. If you do not want voice callers to hear fax
tones, use the Manual setting. But remember that fax calls are not received automatically
when the mode is set to Manual.

To set the answer mode

To set or change the answer mode, complete the following steps:
1. On the control panel, press
2. Use the
3. Use the
4. Press
5. Use the
The control panel display shows the answer mode setting that you specified.
ENWW
Changing the rings-to-answer
MENU
< or the > button to select Fax setup, and then press
< or the > button to select Fax Recv. setup, and then press
/ to select Answer mode.
MENU ENTER
< or the > button to select Automatic or Manual, and then press
setting.
/ on the control panel or by picking
FAX SEND
/ .
ENTER
Setting the answer mode
/ .
MENU ENTER
/ .
MENU ENTER
/ .
MENU ENTER
41