Monogram ZV850 Instructions D'installation page 20

INSTALLATION—RECIRCULATING
7
INSTALL HOOD
NOTE: Before installing the hood, the metal damper
flaps on top of the hood exhaust outlet may be
removed. Do not remove the duct transition.
The damper is not required for this recirculating
operation.
NOTE: TWO PEOPLE ARE REQUIRED TO
COMPLETE THIS INSTALLATION!
into the duct.
8
CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING
If house wiring is not 2-wire with
aluminum-to-copper connectors.
or bare ground lead.
electrical connector.
sure wires are not pinched.
Installation Instructions
wrench.
NOTE: Do not drive screws through this duct
connection. Doing so will prevent proper damper
operation (if present).
9
SLIDE DUCT COVER DOWN,
INSTALL SIDE UTENSIL RODS
Slide the lower duct cover up and above the stop screw.
the hood. The duct cover should be seated into the
pocket on top of the hood.
31-10725 Rev. 6