INSTALLATION—RECIRCULATING
1
MOUNT TEMPLATE
tape in place.
front of the hood.
provide parallel alignment with the countertop
below.
31-10725 Rev. 6
Installation Instructions
Front of Hood
Wire Access Hole
2
INSTALL AIR DEFLECTOR AND
UPPER SUPPORT FRAME
The duct connector is shipped
inside the deflector.
the deflector and remove. Turn it
connector over the opening.
into the upper support frame and
secure with 4 small screws.
and/or cross framing with the 4 screws provided.
be driven into the center of the joists and/or cross
framing.
vertically and horizontally.
plastic connector
is installed on
the bottom of the
deflector as shown.