Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
Before charging the vehicle, make sure that it is sufficiently secured against rolling away!
Do not run the charging unit in a thermally insulated or encapsulated vessel or container due to the risk of overheating.
When using a Smart Attachment, never set a higher charging current than
1) the maximum current the Smart Attachment is approved for.
2) the maximum current the upstream installation and socket are approved for.
If the power supply socket feels hot when charging is in progress, replace this socket immediately!
Never use force to pull on the cable ends of the charging unit!
Never connect or disconnect plug connections between grid connector, Smart Attachment, Connector Unit or vehicle inlet
while the NRGkick is in charging mode!
The use as a rope for lifting or pulling mechanical loads or for wrapping or tying up objects is strictly prohibited!
The charging unit may only be operated in accordance with its intended use!
When removing the cable from the socket pull on the Connector System, never the cable!
Protect the charging unit and the charging cable from mechanical damage (running over, pinching or kinking) and the
electrical contact area from heat sources, dirt and water!
Note that the Smart Attachments must be fitted with the IP 24 protective cover supplied when not connected in order to
provide a sufficient IP protection level.
Only use Smart Attachments and accessories supplied by DiniTech GmbH with the charging unit or those that are approved
by DiniTech GmbH!
The Smart Attachments contain a Neodymium magnet which may not be brought into direct body contact with heart
pacemakers out of safety reasons.
NRGkick contains telecommunication hardware which may not be brought into direct body contact with heart pacemakers
out of safety reasons.
In the following countries the charging current may not be set higher than 10A if a Schuko adapter plug is used: Norway
In the following countries the charging current may not be set higher than 8A if a Schuko adapter plug is used: Finland,
France and Switzerland
EN
In the following countries the charging current may not be set higher than 6A if a Schuko adapter plug is used: Denmark
If a Schuko Smart Attachment is used, the weight of the charging unit must not put strain on the socket. Relieve the strain
on the cable (e.g. by placing the unit on something or hanging the cable over a hook).
During a single phase charging operation within a 3-phase-grid, the requirements of the grid operator for asymmetric grid
loads needs to be considered. The charging power may not be set to a higher value than the maximum single phase power
drain permitted by the grid operator.

4. Intended Use

The charging and all included accessories unit may only be used to charge the drive battery of an electric or plug-in-hybrid
vehicle. Section 5 "Product Description" describes operation of the charging unit.
Any other use will be considered as improper use. DiniTech GmbH does not assume liability for any damage that results from
such improper use!
Intended use includes following the instructions in this manual as well as observance of all labeling such as type plates,
warning notices, current limit marks, display symbols and ambient conditions.
Ver.: 2105-04-1
3

Publicité

Table des Matières
loading

Table des Matières