SLAT AXS3 Notice D'utilisation page 23

1. Open the mains breaker before any connections.
2. Use a AC power mains cabble conform to CEI 60227 or CEI 60245.
Connect first the safety electrical ground to the MAINS connector ground terminal and then
the line and neutral according the picture on the left side.
3. Connect the battery wires to the battery output terminal, but do not connect wires to the
battery.
4. After the electrical connections are made (mains, loads and batteries), close the mains circuit
breaker.
5. Check the load output voltage. The motherboard LED turns red.
6. Connect the battery
7. Check that the motherboard LED turns green (green = everything is ok, red = fault).
8. The mains cable have to be tight to the housing with the tie wrap provided using the hole indicate below
C24
9. Connect the ground wire to the cover if equiped.
10. Close the protective cover.
Your equipment is operational when the 3 LEDs on the front panel are green (mains, battery and charger).
Cabling procedure
C38
Fixing of AC mains power cable
23
C85