HIKOKI CM 5MA Mode D'emploi page 7

The diamond cut-off wheels continue running after
the machine has been switched off.
Always wear protective goggles, dust mask, gloves,
ear protectors and sturdy shoes when working with
this tool.
Damaged, eccentric or vibrating tools must not be
used.
Avoid damage to gas or water pipes, electrical
cables and load-bearing walls (static).
Pull the plug out of the socket before making any
adjustments, converting or servicing the machine.
A damaged or cracked side handle must be
replaced. Never operate the machine with a
defective side handle.
A damaged or cracked safety guard must be
replaced. Never operate a machine with a defective
safety guard.
Do not switch on the tool if parts or guard devices
are missing or defective.
Reducing dust exposure:
Some of the dust created using this power tool
may contain chemicals known to cause
cancer, allergic reaction, respiratory disease, birth
defects or other reproductive harm. Some of these
substances include: lead (in paint containing lead),
mineral dust (from bricks, concrete etc.), additives
used for wood treatment (chromate, wood
preservatives), some wood types (such as oak or
beech dust), metals, asbestos.
The risk from exposure to such substances will
depend on how long you or people nearby are
exposed to them.
Do not let particles enter the body.
Do the following to reduce exposure to these
substances: ensure good ventilation of the
workplace and wear appropriate protective
equipment, such as respirators able to filter
microscopically small particles.
Observe the relevant guidelines for your material,
staff, application and place of application (e.g.
occupational health and safety regulations,
disposal).
Collect the particles generated at the source, avoid
deposits in the surrounding area.
Use suitable accessories for special work. In this
way, fewer particles enter the environment in an
uncontrolled manner.
Use a suitable extraction unit.
Reduce dust exposure with the following measures:
- do not direct the escaping particles and the
exhaust air stream at yourself or nearby persons
or on dust deposits.
- use an extraction unit and/or air purifiers.
- ensure good ventilation of the workplace and keep
clean using a vacuum cleaner. Sweeping or
blowing stirs up dust.
- Vacuum or wash the protective clothing. Do not
blow, beat or brush.
Name of Parts (Fig. 1
1 Lock
2 Trigger
3 Scale for depth of cut
4 Clamping lever for setting cutting depth
5 Electronic signal indicator
6 Marking (serves as cutting indicator of the first
diamond disc)
7 Spindle locking button
8 Extraction nozzle for dust extraction
9 Support wheels
10 Markings show the cutting edges of the
diamond cut-off wheels with maximum cutting
depth
11 Arrow shows the specified thrust direction. The
machine must be pushed through the material
to be processed in this direction.
12 first handle
13 second handle
14 2-hole spanner
15 Safety cover
16 Arrows show the direction of rotation of the
diamond cut-off wheels
17 Clamping nut
18 Diamond cut-off wheels
19 Clamping flange
20 Spacer rings
Symbols
WARNING
The following show symbols used for the machine. Be sure
that you understand their meaning before use.
CM5MA: Wall Chaser
V Rated voltage
Alternating current
n
Rated speed
-1
min Revolution or reciprocations per minute
Class II tool
English
Fig. 6)
–
7