Télécharger Imprimer la page

HIKOKI CM 5MA Mode D'emploi page 10

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
English
Troubleshooting
The machine does not start. The
electronic signal indicator (5) flashes. The
restart protection is active. If the mains plug is
inserted with the machine switched on or if the
power supply is restored following an interruption,
the machine does not start up. Switch the machine
off and back on again.
Accessories
Use only genuine HiKOKI accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
Diamond cut-off wheels: Standard accessory
○ Diamond wheel..................... Order No. 752812
for abrasive materials
(e.g. abrasive cement, sandstone,
sand-lime brick, aerated concrete and similar)
Diamond cutting wheels: Optional accessories
These cutting wheels makes work much easier
since no knocking out of the middle ridge is
required.
○ Diamond wheel (2 rows) ..... Order No. 4100298
○ Diamond wheel (3 rows) ..... Order No. 4100299
for abrasive materials
(e.g. abrasive cement, sandstone,
sand-lime brick, aerated concrete and similar)
It can also be used for concrete.
Repairs
Replacing supply cord
If the replacement of the supply cord is necessary,
it has to be done by HiKOKI Authorized Service
Center to avoid a safety hazard.
Caution! In the operation and maintenance of
power tools, the safety regulations and
standards prescribed in each country must be
observed.
Environmental Protection
The generated grinding dust may contain harmful
substances. Do not dispose with household trash;
dispose of properly at a collection point for
hazardous waste.
Observe the national regulations on
environmentally compatible disposal and on the
recycling of disused tools, packaging and
accessories.
Only for EU countries: never dispose of
power tools in your household waste!
According to European Directive 2012/19/EU
on Waste from Electric and Electronic Equipment
and implementation in national law, used power
tools must be collected separately and recycled in
an environmentally-friendly manner.
10
GUARANTEE
We guarantee HiKOKI Power Tools in accordance
with statutory/country specific regulation. This
guarantee does not cover defects or damage due
to misuse, abuse, or normal wear and tear. In case
of complaint, please send the Power Tool,
undismantled, with the GUARANTEE
CERTIFICATE found at the end of this Handling
instruction, to a HiKOKI Authorized Service
Center.
Information concerning airborne noise and
vibration
The measured values were determined according
to EN60745 and declared in accordance with
ISO 4871.
Measured A-weighted sound power level:
Measured A-weighted sound pressure level:
Uncertainty K: 3 dB (A).
Wear hearing protection.
Vibration total values (triax vector sum) determined
according to EN60745.
Vibration emission value
K
Uncertainty
= 1.5 m/s
h
The declared vibration total value has been
measured in accordance with a standard test
method and may be used for comparing one tool
with another.
It may also be used in a preliminary assessment of
exposure.
WARNING
○ The vibration emission during actual use of the
power tool can differ from the declared total
value depending in the ways in which the tool is
used.
○ Identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of all
parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).
NOTE
Due to HiKOKI's continuing program of research
and development, the specifications herein are
subject to change without prior notice.
111.3 dB (A)
100.3 dB (A)
a
= 5.5 m/s
h
2
2

Publicité

loading