Product Overview; Using The Laser; Using The Tool - Pattfield Ergo Tools PE-600 MHKS-2 Traduction De La Notice D'origine

1
2
3
9
10
11
1
172 EN
4
5
6
5
7
8
12
13
14
15
16
17
2

Product overview

1x
1 Saw blade safety guard
2 Saw blade clamp washer
3 Saw blade
4 Power cord
5 Ventilation slots
6
On / Off switch
7 Depth clamping knob
8 Guide rail for base plate
9 Reset button
10 Dust extraction port 1x
11 Base plate
12 Safety lock switch
13 Laser On / Off switch
14 Laser battery compartment
15 Spindle lock button
16 Parallel guide clamping knob
17
Parallel guide slide in
1x

Using the laser

18. To activate the laser press the laser on /
off switch 13.
19. The laser generates a visible red line on
the surface of the workpiece. The tool will
cut along this line.
20. To deactivate the laser press the laser on
/ off switch 13 again.
DE Caution! Never stare directly into Lieferumfang
the laser beam and do not point it at
anybody. FR Etendue de livraison
IT Materiale compreso nella fornitura
NL Leveringsomvang
SV LASER SET-UP Leveransomfång
1 Make sure the laser is switched off.
CZ Open the laser battery Rozsah dodávky compartment 14
by pushing the compartment lid up-
SK wards. Rozsah dodávky
RO Volumul livrat
GB Scope of delivery

Using the tool

2x
1. Check the correct function of the base
plate 11 before plugging in the power
cord. Push the safety lock switch 12 and
push the base plate 11 upwards. Ensure,
that the safety lock clicks back into place
when the base plate is back in the original
position.
Caution! The saw blade is very
1x sharp. Danger of injury.
2. Choose a corresponding saw blade and
check its condition and sharpness.
3. Make sure you keep the ventilation slots 5
clear when holding the tool.
4. Pull the On / Off switch 6 and wait, un-
til the saw blade has reached maximum
speed. Press the safety lock switch
and slowly push the tool forward through
1x the safely fixed workpiece.
5. Make sure the base plate 11 always rests
evenly on the workpiece.
6. When cutting tiles always ensure, that
they are supported in such a way that
they can not bend and break.
7. To switch off the tool, release the on / off
switch 6.
Caution! Do not overheat the blade
tips of the saw blade.
2 Insert a button cell battery CR2032
as indicated. Afterwards close the
laser battery compartment 14 with
the lid.
Remove the battery after each use.
EN
12
173