Pattfield Ergo Tools PE-600 MHKS-2 Traduction De La Notice D'origine page 88

PARALLEL GUIDE
1 Slide the parallel guide into the parallel
guide slide in 17.
CUTTING DEPTH
1 Open the depth clamping knob 7.
Note: When cutting wood, the cutting
depth should somewhat exceed the
thickness of the material.
RESET
1 The saw will switch off automatically
in case of overloading. Press reset but-
ton 9 to continue.
SAW BLADE REPLACEMENT
1 Press the spindle lock button 15.
Caution! Make sure the tool is
switched off and unplugged and
wear protective gloves.
3 Place a new saw blade in the tool.
Caution! Observe that the rotation
direction of the saw blade corre-
sponds with the indication on the tool.
174 EN
2 Set the desired distance and tighten
the parallel guide clamping knob 16
2 1. Set the desired cutting depth.
2. Close the depth clamping knob 7.
Make a test on a spare piece before
starting on the workpiece.
DUST COLLECTING
2 To connect a dust collection system,
fit the adaptor to the dust extraction
port 10.
2 Loosen the saw blade clamp washer 2
with the hex key and remove the saw
blade 3.
Please refer to chapter „Saw blades"
when selecting the right saw blade.
4 Press the spindle lock button 15 again
and tighten the saw blade clamp wash-
er 2 with the hex key.
Caution! The convex surface of the
big washer must point outwards.
1
1
1
1
3
2
2
2.
1.
2
2
4
EN 175