Product Overview; Intended Use; Adjustments; Using The Tool - Pattfield Ergo Tools PE-160KS Traduction De La Notice Originale

1
2
3
4
5
6
7
8
9
10
1
120 EN
10
20
19
18
17
16
15
14
13
12
11
2

Product overview

1x
1 Power cord
2 On / Off switch
3 Dust extraction port
4 Saw blade guard knob
5 Saw blade / pre-installed
6
Saw blade clamp washer
7 Base plate
8 Saw blade safety guard
9 Auxiliary handgrip
10 Safety button 1x
11 Cutting depth locking lever
12 Depth protractor guide
13 Laser On / Off switch
14 Parallel guide slide in
15 Parallel guide clamping knob
16 Angle clamping knob
17
Angle protractor guide
18 Spindle lock pin
19 Laser
20 Laser battery compartment

Intended use

The tool is intended for sawing longitudinal,
cross and mitre cuts in firmly supported solid
wood, plywood, plastic and lightweight non-
ferrous construction materials. The tool is not
intended for commercial use.
Any other use (e.g. abrasive wheels) or modi-
fication to the tool is considered as improper DE Lieferumfang
use and could cause considerable dangers.
The pre-installed saw blade is intended for FR Etendue de livraison
use with wood only!
IT Materiale compreso nella fornitura
NL Leveringsomvang
SV PARALLEL GUIDE Leveransomfång
1 Slide the parallel guide into the parallel
CZ guide slide in 14. Rozsah dodávky
SK Caution! Make sure the tool is Rozsah dodávky
switched off and unplugged.
RO Volumul livrat
GB Scope of delivery

Adjustments

Using the tool

1x
1. Check the correct function of the saw
blade safety guard 8 using the saw blade
guard knob 4.
2. Connect the power plug to a suitable
socket (see "Technical Data")
3. To switch on the tool, press and hold the
safety button 10 and press the On / Off
switch 2. After start let go the safety but-
ton.
4. Start working, when the tool is at maxi- 1x
mum speed. While holding it firmly with
both hands, slowly push the tool forward
through the safely fixed workpiece.
5. To switch off the tool, release the On / Off
switch 2.
Caution! Do not overheat the blade
tips of the saw blade.

Using the laser

1. To activate the laser slide the laser On /
Off switch 13.
2. The laser generates a visible red line on
the surface of the workpiece. The tool will
cut along this line.
3. To deactivate the laser slide the laser On /
Off switch 13 back.
Caution! Never stare directly into the
laser beam and do not point it at any-
body.
2 Set the desired distance and tighten
the parallel guide clamping knob 15.
EN 121