Product Overview; Intended Use; Using The Tool - Pattfield Ergo Tools PE-20 RSB Traduction De La Notice Originale

1
2
3
4
5
6
1 2

Product overview

1 Unlocking button
2 On /Off switch
3 Insulated grip
4 Footplate locking lever
5
Battery release switch
6 Battery (not included)
7 Pivot footplate
8 Saw blade
9 Blade clamp lever
9

Intended use

8
7
The tool is intended for wood, plastic and met-
al cutting applications. The tool is not intended
for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
CHARGE BATTERY
1 Plug the charger (not included) into a
suitable wall socket.
Caution! Only use the battery
charger specified in technical data
to charge the battery.

Using the tool

1. Place the tool on the workpiece so that
the footplate is in contact. Make sure your
workpiece can not slip. For metal cutting,
always clamp the workpiece down.
2. To switch on the tool, press and hold the
unlocking button and press the on / off
switch 2. Start working, while holding the
tool with one hand at the handle and the
other on the insulated grip 3.Press harder
to increase the speed, press less hard to
decrease it.
3. Let the tool come to full speed and slowly
cut the workpiece.
4. Use a finer blade for ferrous metals and a
coarse blade for non-ferrous metals.
5. When cutting thin gauge sheet metals,
always clamp wood on both sides of the
sheet to ensure a clean cut and prevent
tearing of the metal.
6. Do not force the saw blade 8.
7.
To switch off the tool, release the on / off
switch 2.
Warning! The saw blade becomes
hot during use. Be careful not to
touch it. Burn hazard.
2 Slide the battery 6 (not included) onto
the charger and check its LED:
Red: Charging
Green: Battery is fully charged
Flashing Red: Battery is defective
Flashing Green: Battery is too hot/ cold
EN 129