Spare Parts - SKF LAGD 400 Mode D'emploi

8. Maintenance
The SKF MultiPoint Automatic Lubricator LAGD 400 has been designed for a long and
trouble free life and should last many years if used correctly. To maximise the operating
reliability of the unit, the following recommendations must be followed:
• Use only high quality, stable greases. The types of grease supplied by SKF are
suitable for most applications and are available worldwide.
• Use only new grease cartridges or ill used cartridges with clean grease through the
grease illing nipple.
• Do not expose the lubricants to contaminants since this can eliminate lubrication and
damage both bearings and lubricator.
In the event that the lubricator is damaged, switch off the power supply to the lubricator
immediately. There are no user serviceable parts inside the lubricator.
In the event of a malfunction, return the lubricator to your local authorised
SKF service centre.

8.1 Spare parts

Designation Description
LAGD 400-1 Power kit
LAGD 400-2 Control Kit
LAGD 400-3 Cartridge Kit
LAGD 400-4 Connection Kit
LAGD 400-5 Standard Tube Kit
16
Contents
Back housing complete with power print plate
Front housing complete with control print plate
Cartridge protection cover, feed spring with
follower plate, locking ring, O-ring
20 m (65 ft) 6 x 1,5 mm tube,
20 m (65 ft) 8 x 1,5 mm tube,
4 quick connection couplings
G 1/4 to suit 6 mm tube,
4 adapters to connect 8 mm,
tube to 6 mm tube,
16 compression ittings,
2 Y-connectors, 1 illing nipple
20 mm (65 ft) 6 x 1,5 mm tube
SKF LAGD 400