Fitting The Skf Grease Cartridge; Connection Of Lubrication Tubes To The Lubricator - SKF LAGD 400 Mode D'emploi

Figure 2
Function
AC power
Live
DC power
Steering
External alarm

4.3 Fitting the SKF grease cartridge

Remove the locking ring from the protection cover. Hold the protection cover tightly
to prevent the ejection of the spring. Remove the protection cover, the spring and the
follower plate. Remove the pull cap from the new grease cartridge. Put the new grease
cartridge into the lubricator. Remove the plastic ring from the piston cap of the new
cartridge, but keep the piston in position. The piston is necessary for the correct operation
of the lubricator. Install the spring, the follower plate and the protection cover. Tighten the
locking ring.

4.4 Connection of lubrication tubes to the lubricator

Carefully cut the lubrication tubes to the correct lengths for the application. Before
connecting the tubes to the application, the tubes must be illed with grease.
SKF LAGD 400
Description
Neutral 100-240 VAC
100-240 VAC
Earth ground
+24 VDC
0 V
Earth ground
Input
Output
Input
Output
Terminal
1
2
Earth
1
2
Earth
3
GND
1
2
9