Hilti HY-150 MAX Mode D'emploi page 3

European technical assessment ETA-0 8 / 0 2 0 2
English translation prepared by CSTB
Specific Part
1 Technical description of the product
The Hilti HIT-HY 150 MAX is used for the connection, by anchoring or overlap joint, of reinforcing
bars (rebars) in existing structures made of ordinary non-carbonated concrete C12/15 to C50/60.
The design of the post-installed rebar connections is done in accordance with EN 1992-1-1 and EN
1992-1-2.
Covered are rebar anchoring systems consisting of Hilti HIT-HY 150 MAX bonding material and
the Hilti tension anchor HZA-R sizes M12 to M24 or an embedded straight deformed reinforcing
bar diameter, d, from 8 to 25 mm with properties according to Annex C of EN 1992-1-1 and EN
10080. The classes B and C of the rebar are recommended. The illustration and the description of
the product are given in Annexes A.
2 Specification of the intended use
The performances given in Section 3 are only valid if the anchor is used in compliance with the
specifications and conditions given in Annexes B.
The provisions made in this European technical assessment are based on an assumed working
life of the anchor of 50 years. The indications given on the working life cannot be interpreted as a
guarantee given by the producer, but are to be regarded only as a means for choosing the right
products in relation to the expected economically reasonable working life of the works.
3 Performance of the product
Mechanical resistance and stability (BWR 1)
3.1
Essential characteristic
Characteristic resistance under static and quasi-static
loading
Safety in case of fire (BWR 2)
3.2
Essential characteristic
Reaction to fire
Resistance to fire
Hygiene, health and the environment (BWR 3)
3.3
Regarding dangerous substances contained in this European technical approval, there may be
requirements applicable to the products falling within its scope (e.g. transposed European
legislation and national laws, regulations and administrative provisions). In order to meet the
provisions of the Construction Products Directive, these requirements need also to be complied
with, when and where they apply.
Safety in use (BWR 4)
3.4
For Basic requirement Safety in use the same criteria are valid as for Basic Requirement
Mechanical resistance and stability.
Protection against noise (BWR 5)
3.5
Not relevant.
Page 2 sur 25 | 2 5 / 0 6 / 2 0 1 8
Performance
See Annex C1
Performance
Anchorages satisfy requirements
for Class A1
No performance assessed