Publicité
Les langues disponibles
Les langues disponibles
V1.0
1.
Twist or tape cables together and prevent coils.
2.
Do not drape cables on your body.
3.
Keep the welding power source and cables as far away
from the user as practical. A minimum of 24 in. is
recommended.
4. Connect the workpiece clamp as close to the weld as
possible, but lay the electrode and workpiece cables away
from the user.
5.
Use the lowest current setting possible during welding.
6.
Avoid long and regular bursts of energy while welding.
Apply the electrode in short strokes and intermittently. This
will prevent the pacemaker from interpreting the signal as a
rapid heartbeat.
7.
Do not allow the electrode to touch the metal while welding.
8.
Wrap the Arc lead cable and ground cable together
whenever possible.
9.
Keep the Arc lead cable and ground cables on the same
side of your body.
UNPACKING
WARNING! Do not operate the tool if any part is missing.
Replace the missing part before operating. Failure to do so
could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and
inspect for damage. Make sure that all items in the parts list are
included.
Contents:
•
ARC 170 dual voltage ARC/TIG welding unit
•
Ground lead and ARC lead
•
PVC carry case
The TIG torch, accessories and parts are sold separately.
Visit www.princessauto.com for more information
ARC 170 DUAL VOLTAGE ARC/TIG WELDER
8611295
19
Publicité
