Publicité
Les langues disponibles
Les langues disponibles
V1.0
5.
Only use insulated connectors to join welding cables.
6.
Ensure there are no contacts between the workpiece and
work area that would allow it to ground, other than through
the ground cable circuit
7.
Do not exceed the duty cycle or amperage required
for the type of welding. Excessive amperage can cause
the deterioration of protective insulation and create a
shock hazard.
8.
Unplug the welding unit when not in use as the unit as
current is still entering the unit, even when it is turned off.
9.
Frequently inspect input power cable for wear and tear,
replace the cable immediately if damaged. Bare wiring is
dangerous and can kill.
10. Do not use damaged, under sized or badly joined cables.
11. Do not disconnect the power cord in place of using the
ON/OFF switch on the tool. This will prevent an accidental
startup when the power cord is plugged into the power
supply.
11.1 In the event of a power failure, turn off the machine as
soon as the power is interrupted. The possibility of
accidental injury could occur, if the power returns and
the unit is not switched off.
12. Make certain the power source conforms to requirements
of your equipment (see Specifications).
POWER TOOL PRECAUTIONS
This equipment requires a dedicated 115/230 volt, 36 amp
single-phase alternating current circuit equipped with a
similarly rated circuit breaker or slow blow fuse. Do not run
other appliances, lights, tools or equipment on the circuit while
operating this welding unit.
1.
Do not drape or carry coiled welding cables on your body
when the cables are plugged into the welding unit.
Visit www.princessauto.com for more information
ARC 170 DUAL VOLTAGE ARC/TIG WELDER
8611295
17
Publicité
