Publicité
Les langues disponibles
Les langues disponibles
V1.0
3.2 Ventilation exhaust shall be directed to a non-work area
to avoid exposing other people to potential toxic or
dangerous fumes.
3.3 Air removed from the work area by the ventilation system
must be replenished with fresh air to avoid oxygen
starvation or a build-up of fumes or gases. Only use air to
provide ventilation. Any other combination of gases may
be explosive or toxic to people in the work area.
3.4 Ventilation methods that remove gas and fumes from
the welding point before they reach the welder's face
should be given preference.
4. Avoid welding in a work area that has vapours from cleaning,
degreasing or any spraying operations. The heat and light
from welding can react with the vapour and form irritating or
potentially toxic gases. Wait for the vapours to disperse.
5.
Consult the manufacturer's Safety Data Sheets (SDS) for
instructions and precautions about metals, consumables,
coatings, cleaners and degreasers.
5.1 Do not weld on coated metals such as galvanized, lead
or cadmium plated steel, unless the coating is removed
from the weld area. The coatings and any metals
containing these elements can give off toxic fumes
during the welding process.
5.2 Do not weld, cut or heat lead, zinc, cadmium, mercury,
beryllium or similar metals without seeking professional
advice and inspection of the welding area's ventilation.
These metals produce extreme toxic fumes, which can
cause discomfort, illness and death.
5.3 Do not weld or cut near chlorinated solvents or in areas
that chlorinates solvents can enter. The heat or
ultraviolet light of the arc can separate chlorinated
hydrocarbons into a toxic gas (phosgene) that can
poison or suffocate the user or bystanders.
Visit www.princessauto.com for more information
ARC 170 DUAL VOLTAGE ARC/TIG WELDER
8611295
13
Publicité
