Recommendations For A Proper Access To The Model - Modine ECO AGS1 Manuel Technique

8. Recommendations for a proper access to the model

AGS1
Preliminary assembly
8 1 Install the drain connection R1 with relative gasket.
8.2 In models AGS1**H3 and AGS1**H3ED, connect electric heater R0 and the motors by breaking through one of the
knockout entries; use the rubber fairlead supplied to prevent damage to the cables.
8 3 In models AGS1**L4 and AGS1**L4ED, electric heater R0 and motors are already connected in junction box SD: use
anyway the knockout entries and the rubber fairleads for electrical connections.
8 4 Use screws "C", washers "D" and grommets "E" as shown in the figure to close and fasten fan shroud L1.
Access
8 5 Remove the drain connection R1 so that the movement of the fan shroud L1 is not hindered.
8 6 Loosen the knurled screws "F" and unscrew the fixing screws "C" of the fan shroud L1.
8 7 Move fan shroud L1 to the position shown in the figure.
Reassembling
8 8 Bring fan shroud L1 into position, making sure that the L2 casing remains inside it, tighten knurled screws "F" and secure
it with screws "C".
8 9 Reassemble the drain connection R1.
L1 = Fan shroud
L2 = Casing
MF = Heater clip (ED models)
R0 = Electric heater (ED models)
R1 = Drain connection
SD = Junction box (standard on AGS1**L4 and AGS1**L4ED models)
Figure 4
37
www.modine.com