Proper Access To Model; Fan Motor Connection Scheme - Modine GME Série Manuel Technique

Proper access to model

Access
1. Disconnect drain connection and ensure that it does not hamper with the
handling of the fan shroud.
2. Unfasten screws "A" and "B" that secure the fan shroud to the casing and
carefully bring the fan shroud to the position shown in drawing.
3. Unfasten screws "C" and remove side panels.
4. To reach the heater positioned under the coil, remove drip tray secured
with screws "E".
5. In order open the heater terminal box (models ED and EDP), remove the
self-threaded screws "D" that fasten the right-hand side front cover.
6. For quick access to header side of coil, remove self-threaded screws "D"
that fasten the left-hand side front cover.
Remounting
1. Refasten drip tray with screws "E".
2. Place front covers back and fasten them with screws "D".
3. Refasten side panels with screws "C"
4. When closing the fan shroud it is necessary position the side panels inside,
subsequently fasten it with screws "A" and "B".
5. Reconnect condensate drain connection.

Fan motor connection scheme

Feed: 230V/1/50-60Hz
GME Model 41GH4
41EH4
41GL7
41EL7
41FL7
Fan motors 1x250
Fan motors A 0,68
absorption W 95
Heaters terminal box Fan motors terminal box
(internal)
L = Brown or grey N = Blue
P.E. = Casework earth connection
12
www modine com
42GH4 43GH4
42EH4 43EH4
42GL7 -
42EL7 43EL7
42FL7 43FL7
2x250 3x250
1,36 2,04
190 285
Motor n. 2/3/4
= Yellow/Green
Side
panel
C
Inner drip tray
Fan shroud
A
44GH4
44EH4
Important
-
The motors are equipped with inner thermal protection
44EL7
with automatic reconnection.
44FL7
4x250
Before using motor speed control systems verify the com-
2,72
patibility with the motors;
380
Non compatible systems may damage motors or increase
noise level; the manufacturer will not be responsible for
model performance with speed control systems.
Motor n. 1
Quick cable connections
Frontal
cover
E
B
Terminal box
L N
D
P.E.