Modine ECO AGS1 Manuel Technique page 42

Heater connection diagram
Important. Application of adequate thermal control systems on feeder lines is mandatory. Performance of all electric
heaters must be periodically controlled to avoid damage due to ice build-up. Modine is not liable in any way for defects
caused by non detected malfunctions. For models supplied with wiring in a junction box, remove the cover to make the
connection. It is compulsory to use power cables with a minimum cross-section according to the technical standards
in force in the country of installation, depending also on the laying method, the length of the cables and their type. To
minimise the risk of indirect contact, it is advisable to earth the unit, using the earth pole (where present). For further
information please refer to the diagrams supplied with the model.
AGS1 - Ø200 fan diameter unit
RBB
Model
Rows
Total power
42
www.modine.com
230V / 1 / 50-60Hz
L
N
L
RBB
N
SD
AGS "ED" 11EH3 11AH3
Ø200 11EL4 11AL4
4 6
W 340 340
= yellow-green
= black
= black
= low power electric heater in coil
= junction box (standard on AGS1**L4 and AGS1**L4ED models)
12EH3 12AH3 12LH3 12MH3
12EL4 12AL4 12LL4 12ML4
4 6 6
450 480 480
13EH3 13AH3 13MH3
13EL4 13AL4 13ML4
6 4 6 6
600 760 840 840
14MH3
14ML4
6
1120