Delaying The Cooking; Using The Timer - Atag OX6011K Mode D'emploi

how to use your oven

delaying the cooking

Température
Durée / Fin de Cuisson
ET
Temps
SET
how to use your oven

using the timer

Température
Durée / Fin de Cuisson
ET
Temps
GB 58
Proceed as you would for a programmed cooking cycle . Then, after setting the
cooking time:
Minuteur
flashing.
The display flashes to show that adjustment is now possible.
Press on the
Having done this, the start up of the heating of your oven will be delayed
to ensure that cooking finishes at 13.00.
When the cooking time is over (the pre-programmed time ends)
To stop the bleeper, press any button on the oven front. The time is
displayed again.
In the case of pre-programmed cooking the oven cavity is lit until cooking
begins and once cooking is finished.
In the case of pre-programmed, fan-assisted cooking, if the function selec-
tor is not reset to 0, the fan continues to operate in order to even out the
temperature in the oven.
Your oven is fitted with an electronic timer for your use other than
in conjunction with the oven.
For this, the timer display makes the hour of day temporarily disappear.
Minuteur
flashing timer symbol appears.
required. (up to 60 minutes)
A few seconds later the display stops blinking and you will see the count-
down taking place. When the timer reaches 0, it will beep to let you know.
NOTE : You can modify or cancel the timer setting at any moment.
Press the SET button until the end of cooking symbol
+ -
or button:
Example: 13.00
- The oven switches off,
- The cooking time symbol goes out,
- The display shows 0:00
- The oven gives a series of bleeps for several minutes.
Press the SET button. The display starts flashing and a
+ -
Press or until the display shows the length of cooking time
starts