Customising The Cooking Temperature; Programming The Cooking; Delaying The Cooking - Atag OX30 11C Mode D'emploi

customising the cooking temperature

When you select your cooking mode, or during cooking, you can
modify the temperature:
Press the °C touch control for about 2 seconds until the
temperature figures start flashing.
Adjust the temperature setting using the
indicate the temperature you wish to memorize.
Confirm your choice by pressing the °C touch control.
The next time you use your oven, the temperature you have just registered
will memorized.
You may repeat this operation for personalizing cooking temperatures as
often as you like.
Set the mode of cooking required and adjust the temperature if necessary.
example: conventional cooking setting
temperature 220°C.
- Press the "cooking time" touch control
The cooking time flashes as 0.00; the symbol
to indicate that it may be adjusted.
Use the + or - touch controls to adjust the figure to the time
required.
Example: 25 min. cooking.
The adjusted time is automatically validated after a few seconds or
may be confirmed by pressing on the
The symbol then stops flashing. The oven then heats up.
At the end of the cooking time the oven bleeps for a few minutes and the
symbol flashes.
Stop the bleeps by pressing on the START/STOP touch control for 1 second.
You can consult or change the end of the cooking time at any time by
pressing the touch control.
To cancel your program, press the START/STOP touch control.
how to use your oven
+
or
how to use your oven

delaying the cooking

also flashes
touch control again.
-
touch controls to
GB 55