Preferred program
configuration
Allows two preferred icons to be set on the main
icon bar.
After the list of the configuration programmes is
displayed, proceed as follows:
Select the preferred programmes icon
-
.
-
All the utility and balancing programmes
are displayed.
-
Select the two programmes to be displayed
in the main window by using the Kis knob or
ENTER button.
-
Press the Exit button to save the setting and
exit
.
Customisation Configuration
This programme allows the permanent storage
of some selected data, such as: name, surname,
city, street, telephone number, advertising mes-
sages, etc.
The stored data are visualised on the initial screen.
To access this programme you must:
• select the icon Utility programmes;
• select the icon Configuration programs;
• and select the icon Company data setting.
The screen which appears has:
• 4 lines for inserting the data;
• 3 lines for inserting the operator data;
• and 5 icons:
1. the Help icon,
2. the Logo icon,
3. the Capital/small letters icon,
4. the Operator data insertion icon,
5. and the Data insertion icon.
To insert the data, you must:
• Select the Operator data insertion or Data inser-
tion icon.
• Select the character with the Kis knob or the
arrow keys.
• Confirm by pressing the Kis knob or ENTER
button.
To save the settings and exit the program, select
the Exit
button.
78
You are advised to set your own surname and name
on the first line, the city on the second line, the
street on the third line and the telephone number
on the fourth line.
The language of the messages displayed on the
monitor can be selected.
After the list of the setting programmes is dis-
played:
icons
-
-
-
This programme can be exited only by selecting a
language, then the unbalance image is displayed
again.
It is possible to activate or deactivate the LED
light when present on the machine.
After the list of the setting programmes is dis-
played:
- Select the lighting LED activation/deactivation
icon
- Three icons will appear on the display that
represent the possible light modes, as shown
below:
LED1. In this configuration, the light turns on
LED2. In this configuration, the light turns on
EM 9580 Plus - EM 9580 C Plus - Operator's manual
Language configuration
Select the language setting
A list of flags is displayed. Select the flag
corresponding to the desired language by
pressing
the Kis knob or
Press the Exit button to save the setting and
exit
.
Lighting LED activation/
deactivation
when:
- at the end of a spin cycle if residual unbal-
ances are present for 30 seconds;
- in CP (centred position) for an additional 30
seconds.
in the conditions indicated for the LED1
programme and, in addition, also in the
following conditions:
- when the internal sensor is extracted. When
the sensor returns to the rest position, the
icon.
the ENTER button .