Maintenance; Information Regarding Machine Demolition; Environmental Information - Corghi EM 9580 Plus LaserLine Manuel D'utilisation

Équilibreuse
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 88
The wheel balancer provides
unsteady unbalance values
The machine was jolted during the spin.
- Repeat the wheel spin while making sure that
nothing affects machine operation while acquis-
ition is in progress.
The machine does not firmly rest on the floor.
- Make sure that the floor support is firm.
The wheel is not locked correctly.
- Tighten the locking ring nut firmly.
Several spins are to be performed
to balance the wheel
The machine was jolted during the spin.
- Repeat the wheel spin while making sure that
nothing affects machine operation while acquis-
ition is in progress.
The machine does not firmly rest on the floor.
- Make sure that the floor support is firm.
The wheel is not locked correctly.
- Tighten the locking ring nut firmly.
- Make sure that the accessories used for centring
are suitable and original.
The machine has not been calibrated correctly.
- Perform the sensitivity calibration procedure.
The entered geometric data are not correct.
- Make sure that the entered data correspond
to the wheel dimensions and correct them if
necessary.
- Carry out the external sensor calibration pro-
cedure (width).

MAINTENANCE

WARNING
the manufacturer
is not to be held responsible for
any claims deriving from the use of non-original
spare parts or accessories.
WARNING
Unplug the machine from the power supply
and make sure that all moving parts have been
locked before performing any adjustment or
maintenance operation.
Do not remove or modify any part of the machine
(except for service interventions).
CAUTION
Keep the work area clean.
84
Never use compressed air and/or jets of water
to remove dirt or residues from the machine.
Take all possible measures to prevent dust from
building up or raising during cleaning operations.
Keep the wheel balancer shaft, the securing
ring nut, the centring cones and flange clean.
These components can be cleaned using a brush
previously dripped in environmentally friendly
solvents.
Handle cones and flanges carefully so as to avoid
accidental dropping and subsequent damage that
would affect centring accuracy.
After use, store cones and flanges in a place where
they are suitably protected from dust and dirt.
If necessary, use ethyl alcohol to clean the dis-
play panel.
Perform the calibration procedure at least once
every six months.
INFORMATION REGARDING
If the machine is to be scrapped, remove all
electrical, electronic, plastic and metal parts and
dispose of them separately in accordance with
current provisions as prescribed by law.
The following disposal procedure shall be exclus-
ively applied to the machines having the crossed-
out bin symbol
This product
that can be hazardous to the environment and
to human health if it is not disposed of properly.
The following information is therefore provided
to prevent the release of these substances and to
improve the use of natural resources.
Electrical and electronic equipment must never be
disposed of in the usual municipal waste but must
be separately collected for their proper treatment.
The crossed-out bin symbol, placed on the product
and on this page, reminds the user that the product
must be disposed of properly at the end of its life.
In this way it is possible to prevent that a non
specific treatment of the substances contained
in these products, or their improper use, or im-
proper use of their parts may be hazardous to the
environment or to human health. Furthermore, this
EM 9580 Plus - EM 9580 C Plus - Operator's manual
MACHINE DEMOLITION
ENVIRONMENTAL
INFORMATION
on their data plate.
may contain substances

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Em 9580 c plus laserline

Table des Matières