Corghi EM 9580 Plus LaserLine Manuel D'utilisation page 50

M
S
Wheel guard and related
support mounting procedure
- Mount the bush (A, fig. 7) on the rotation pin (B,
fig. 7). While doing this, make sure that the groove
on the pin is aligned with the plug in the bush.
B A
- Block the bush on the pin using the M12 screw
supplied with the machine.
- Insert the metal tube (D, fig. 8) into the two plastic
guard front holes (C, fig. 8).
50
V A
5
6
7
EM 9580 Plus - EM 9580 C Plus - Operator's manual
- Couple the guard to the rear side of the tube by
inserting it into the correct position with snap-on
coupling (E, fig. 8).
- Lock the guard by tightening the screw F
(fig. 8).
Assembly of the ultrasonic
sensor and its "optional
accessory supplied on request"
support for automatic width
measurement
- insert the ultrasonic sensor cable inside the slots
in the metal pipe (see fig.9.
8
9