Configuration Programs; Selection Of Adhesive Weights Application Position - Corghi EM 9580 Plus LaserLine Manuel D'utilisation

Équilibreuse
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 88
- select the balancing programme icon
- press the Kis knob or the ENTER button.
Each time the Kis is pressed, the machine
automatically changes the type of balancing
programme (as shown on the graphic on the
video) in the following sequence:
Dynamic
ALU1
ALU2
ALU3
ALU4
ALU5
Motorcycle dynamic
Motorcycle ALU
STATIC
Function open / close
automatically locking C
If the control pedal C (L, Fig.11) or the WINUT
device fails to function, you can open/close the
locking device C in the following way:
- select the
- press the Kis knob or the ENTER key to open/
close the automatic locking device C.
This function can be inserted in the bar of the main
icons, as explained in Preferred Programme
Configuration.
CONFIGURATION
PROGRAMS
The Configuration programmes are those func-
tions that are intended for customising the
machine's operation and are normally executed
when the machine is installed.
The list of the configuration programmes can be
displayed as follows:
-
Select the utility and configuration pro-
grammes icon
-
Select the configuration programmes icon
.
76
icon
.
EM 9580 Plus - EM 9580 C Plus - Operator's manual
Automatic Position Search
(RPA) Configuration
Enables/disables the automatic positioning of
the wheel at the end of the spin. After the list of
the setting programmes is displayed, proceed
as follows:
Select the Automatic position search con-
-
figuration icon
The following icons are displayed:
RPA OFF; disables the automatic position search
procedure.
RPA ON; enables the automatic position search
procedure.
-
Press the
the Kis knob or
select the icon desired.
-
Press the
setting and exit.
The selection can also be seen in the working
screen status line.
Selection of adhesive weights
application position
To access this programme you must:
- select the Utility programmes icon,
- select the configuration programmes icon
- Three icons will appear on the display that rep-
resent the possible positions, as shown below:
H12: the balancing weight must always be applied
in the 12 o'clock position regardless of the type
of balancing programme selected or the type
of weight to be applied (adhesive or spring);
LASER: the balancing adhesive weight must be
applied in correspondence of the laser line (in
all balancing programmes) whereas the clip
weight must always be applied in the 12 o'clock
position. If the laser line is faulty, the balancing
adhesive weight can be applied in the 6 o'clock
position; the H6 icon will appear on the screen
instead of the LASER icon.
.
ENTER button to
Exit button to save the

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Em 9580 c plus laserline

Table des Matières