Technical Specifications - VINCENT CD-S8 Manuel D'utilisation

Symptom
No audio playback
on one channel
The remote control
cannot perform
any functions
Humming low
frequency noise is
audible, even as
no audio source is
playing back
D/A converter:
Frequency response:
Total Harmonic Distortion:
Signal to Noise Ratio:
Dynamic Range:
Output impedance:
Audio Output Voltage:
Channel Separation:
Inputs:
Outputs:
AC power connection type:
Dimensions (WxHxD):
Weight:
Colour:
Tubes :
Vincent
42
SEARCH FOR ERRORS
Possible Cause
One of the signal cables between CD player
and amplifier input has not yet been plugged
in or is defective.
One of the loudspeaker cables or (if you are
using pre & main amplifiers) one of the signal
cables between pre and main amplifier is not
correctly connected or is faulty.
No batteries inserted in the remote control,
batteries are not inserted correctly or are
depleted.
The line-of-sight between the remote control
and the unit is obstructed, the range was
exceeded or the hand unit was operated from
a position too far to one side.
The unit is not switched on.
See section "Net frequency noise" in the
chapter "Tips".

TECHNICAL SPECIFICATIONS

24 bit / 192 kHz
20 Hz - 20 kHz
< 0.003 %
> 90 dB
> 100 dB
600Ω
2.5 V
> 90 dB
1x 3.5mm Jack (Power Control)
1x stereo XLR, 1x stereo RCA, 1x digital Coaxial,
1x digital Optical, 1x 3.5mm Jack (Power Control)
220V – 240V / 50 Hz
430 x 135 x 368 mm
10.8 kg
black/silver
2x 6922 (= 6DJ8), 1x 12AX7
Countermeasure
Check the cable connections, tighten them if
necessary.
Check all the connections of the amplifiers
and whether the loudspeakers are working.
Check and replace the batteries if necessary.
Try to point the remote control at the front of
the unit only when the sight-line is clear,
within a 7-metre distance and, if possible,
facing the unit.
Switch on the unit.
See section "Net frequency noise" in the
chapter "Tips".