VINCENT CD-S8 Manuel D'utilisation page 28

16
16. ANALOG OUTPUT:
analogue audio signal outputs
Either the RCA connectors or the XLR sockets
("BALANCED") must be connected to the relevant
input of the amplifier, preamplifier etc. It is not
necessary to also connect one of the digital signal
outputs (17).
17. DIGITAL OUTPUT:
digital audio signal outputs
If the amplifier, receiver or preamplifier is equip-
ped with a digital coaxial or optical digital input
connector, the corresponding CD player signal
output may be connected to this. It is not necessa-
ry to connect an analogue (16) and a digital
signal output (17) at the same time.
Vincent
28
REAR VIEW
17
18. POWER CONTROL (12V): ON/OFF control
These jack connectors (3.5 mm) receive and for-
ward the signal for the standby control (12V
Trigger).
19. AC power connector and fuse holder
To establish the power supply, connect the plugs
of the power cable to the device and to a wall
power outlet. The small plastic housing beneath
the plug opening holds the fuse. Refer to the secu-
rity precautions.
18 19