VINCENT CD-S8 Manuel D'utilisation page 39

Operation
Indication of the remai-
ning playing time
Switch between normal
and random playback
Switch between
playing the content
of the CD once, repea-
ting an individual track
and repeating all the
tracks on the CD
Repeat a custom section
of the track as an end-
less loop
Play a short introduction
of every track
OPERATING THE APPLIANCE
ADVANCED PLAYBACK FUNCTIONS
Button(s) Description
After pressing this key while the CD is playing, the remaining time of the
current track will be shown (indicated by the text "REMAIN" in the display
(9)). Pressing the key again switches the display to the remaining playing
REMAIN
time of the entire CD or the entire program, with the display then showing
(5)(21)
"REMAIN ALL". Pressing the key a third time switches back to the normal
playing time display. This key is located both on the front of the device
and on the remote control.
The function activated with this remote control button ensures that all the
CD tracks are played in random order. This function cannot be used for
playing a program set up with "PGM" (32). If this button is pressed during
RANDOM play or pause, the current track is stopped and the playing of all the CD
tracks in random order begins. In the display, this play mode will be indica-
(11)(33)
ted by the text "RAN". Pressing the "RANDOM" button again switches off
random playing and playing will continue from the current position. This
key is located both on the front of the device and on the remote control.
If this button is pressed once while the CD is playing, the current track will be
played over and over again when it has finished. In the display (9) this ope-
ration mode is indicated by the text "REPEAT 1". If this button is pressed twice
while the CD was playing, then the entire CD or the entire program will be
REPEAT (25) played over and over again when it has finished. In the display this operation
mode is indicated by the text "REPEAT ALL". A third press of the key switches
this function off. The desired repeat mode can also be switched on even
when play is stopped or for a selected program (32). This key is located only
on the remote control.
While the CD is playing, the first press of this key marks the start of the section
(A) and the second press marks the end of this section (B). As soon as both
points are selected, the player continues to play the marked extract over and
over again until the "A-B" key is pressed again or "STOP" (14)(28) is pressed.
A-B (6)(23)
In the display (9) this play mode is indicated with the symbol "A
A-B playback has been stopped with the key "STOP" (14)(28), the marked
points will be deleted. This key is located both on the front of the device and on
the remote control.
You can press this remote control key if the beginning of every track is only to
be played for a brief time. In this mode the first ten seconds of the track will
be played then it will skip to the next track in the sequence. This function is
also known by the term "Intro Scan". Even if a program has been set up for
the play sequence (32), all the CD tracks will each be played once for a brief
INTRO (24)
time after the "INTRO" key has been pressed. Pressing this key again ends the
Intro Mode and continues playing the remaining section from the current posi-
tion onwards. The text "INTRO" will be shown on the display (9) while the
"Intro Scan" is active. If this key is pressed during play or pause, the Intro
Mode always starts with the first CD track.
÷
B". After the
Vincent
39