Tylo Prime+ 1515/C Mode D'emploi page 7

Bench Top (Box #1):
• Slide the Long Bench seat down against the back wall with Power Junction Box facing you.
•
Tilt the Bench against the Back Wall so it will remain standing.
Electrical Connections (under bench - left side):
• Connect wire L1 from the distribution plate to L1 from the Left Wall panel.
• Connect wire L2 from the distribution plate to L2 from the Left Wall panel.
•
Connect wire B1 from the distribution plate to B1 from the Left Back Wall panel.
•
Connect wire B2 from the distribution plate to B2 from the Left Back Wall panel.
•
Connect wire #6 from the distribution plate to #6 from the Bench Top.
•
Connect S2 from the distribution plate to S2 from the Bench Top.
•
Connect S4 from the distribution plate to S4 from the Bench Skirt.
Bench Top (Left Side):
• Install the left Bench Top by tucking the back of the bench under the heater guard. Push
Bench Top all the way to the Left Back Wall.
• The Bench Top should fit down flush from front to back. It may be necessary to use the
openings in the skirt to apply pressure forward or rearward on the skirt to allow the bench to
drop into place.
3-4 Person Infrared Sauna Prime+ 1515C Page 7 150612
Rev. 3