Replace The Aerator Rod; Storage/Overwintering; Wear Parts; Disposal - Oase Profi Clear Premium Compact L US Notice D'emploi

8.9

Replace the aerator rod

How to proceed:
 V
1. Remove approx. 2/3 of the Hel-X bio-elements and keep moist. After completing the maintenance
measures, return the Hel-X bio-elements to the container.
2. Pull the aerator stone out of the clamping holder at the bottom of the container.
3. Disconnect the hose from the aerator stone and connect it to the new aerator stone.
– Fasten the connecting hose with a cable tie.
4. Push the aerator stone back into the clamping holder.
9

Storage/overwintering

The unit is protected from frost (e.g. stored in a garage or other enclosure)
The unit can be operated as long as the water temperature does not drop below 39 °F (+4 °C).
► Set the interval for time-dependent cleaning to 20 minutes to avoid damage to the rinsing device in
the event of frost.
► Install the control system in such a way that it is protected. The minimum operating temperature of the
control system is 14 °F (-10 °C).
The deeper areas of the pond have a water temperature of approx. 39 °F (+4 °C) in winter and are vital
for fish. Take the following measures to reduce the cooling effect on the water during circulation by the
filter system:
► Position the pump closer to the surface of the water so that only colder water closer to the surface of
the pond enters the pump.
► Insulate the return pipes from the filter system into the pond.
► Do not allow water to flow into the pond via a stream.
The unit is not protected from frost (e.g. outdoor installation)
Shut down the unit at water temperatures below 46 °F (+8 °C) or, at the latest, when freezing temperatures
are expected.
► Drain the unit as far as possible, clean thoroughly and check for damage.
► Empty all hoses, pipes and connections as far as possible.
► Leave the slide valves open.
► Cover the container so that no rain water can enter.
► Protect pipes and slide valves that are in contact with water from frost.
10

Wear parts

► Capacitor of the rinsing pump
– Do not open the rinsing pump. Send the rinsing pump to OASE. You will be sent an immediate
replacement.
► Safety fuse
► Screen elements
► Drum seal
► Aeration stone and air hoses
11

Disposal

N O T E
Do not dispose of this unit with domestic waste.
► Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return
system provided for this purpose.
Questions, problems, missing parts?
Before returning to your retailer, call us at 1-866-627-3435, 8 a.m.-6 p.m., EST, Monday-Friday, or email
us at customercare@oase-livingwater.com. Or visit our website at www.oase-livingwater.com
- EN -
41