Oase Profi Clear Premium Compact L US Notice D'emploi page 35

System message Functions that are still
available
Motor blocked None
Er44
(The control system attempted
to start up the motor three
times - 5 times per attempt)
More than 960 cleaning cycles
Er55 • Manual cleaning
in 48 hours
• Automatic mode
• Time-dependent cleaning
Switch element for rinsing None
Er66
pump in the control system
overheated
The filter pump is not supplying
Er88 • Manual cleaning
any water or insufficient water.
• Automatic mode
• Time-dependent cleaning
Questions, problems, missing parts?
Before returning to your retailer, call us at 1-866-627-3435, 8 a.m.-6 p.m., EST, Monday-Friday, or email
us at customercare@oase-livingwater.com. Or visit our website at www.oase-livingwater.com
Possible cause Remedy
Filter drum rotating sluggishly or jammed • Clean edge of the drum/drum seal and grease edge of the
drum Only use original OASE grease (order number 27872).
• Ensure that the rollers move smoothly
• Remove larger particles (e.g. snails, stones) from the sprocket
The lips of the drum seal were squeezed Disassemble the drum and ensure that the drum seal is
when the drum was installed. positioned correctly during re-assembly
The drum load is distributed unevenly Align the container horizontally
Temporary heavy soiling Wait until the soiling decreases
• Start-up phase of the filter system (e.g. • This operating status is atypical. Avoid long-term operation in
during the first start-up) this state.
• Fish are spawning
Pond heavily soiled • Clean the pond
• Reduce the amount of soiling
• Install the filter pump in an elevated position.
Screen elements heavily soiled Clean the screen elements, descale (→ Replacing screen
element)
Insufficient cleaning effect due to soiled
• Clean nozzle
nozzle
Water level in the system too high:
• Outlet pipes soiled • Clean outlet pipes
• Outlet opening too small • Enlarge outlet opening
• Max. flow rate exceeded • Reduce flow rate
• A large amount of dirt has entered the • Clean foam filters
filter system, water is flowing over
(instead of through) the foam filters.
Control system is exposed to excessive Protect the control system from heat
heat (sun, ambient temperature)
Pump status detection incorrectly set Set the pump status detection. (→ E7: Pump status detection)
The filter pump is switched off. Switch on the filter pump.
The impeller unit of the filter pump is Clean the filter pump.
blocked.
- EN -
Resetting the system
message
Press key for 5 s
• Press key for 5 s
• Automatic if the number of
cleaning procedures drops
below 960.
Automatic when cooled down
Automatic after elimination of
the cause
35