Dentsply Sirona Biodent K+B Plus/OVS II Mode D'emploi page 17

Liquids
Liquid S
Liquid N
Liquid K
Accessories
Protective varnish
Promotor K
Mixing vessel for Promotor K
Mixing palette with glass lid
Set of brush tips (10 pieces)
Measuring spoon
Single Components
OVS II Opaque
OVS II Opaquer thinner
OVS II Opaque
The opaque is in liquid form and therefore ready for immediate use . Shake the bottle well
before using and replace the stopper immediately after use .
Clean, degrease and dry the metal surface and apply the opaque from the phial with a fine
sable brush . The metal must be rough, not smoothed by sand-blasting or electrolytical ly
(e .g . aluminium oxide, 125 μm) .
Brush the opaque on thinly and evenly . Apply dentine opaque first, let it dry and then
paint on the neck opaque .
With plastic jacket crowns, first insulate the die and then apply opaque to the well-dried
insulating film .
Flask Method
Apply opaque after the crown or bridge has been bedded in and the wax boiled out .
Drying Timer
Opaque hardens at room temperature in 15 minutes . Alternatively, the bridge frame with
its covering of opaque may be heated at 60–90 °C (e .g . before an infrared lamp) for at
least 5 minutes .
Thin Veneers
The less room there is for the veneer, the harder it is to get the required Biodent shade,
depth effect and body . Here the proper use of the additional opaques on top of the neck
opaques will be of assistance . Thus, for example, the dentine opaque can be lightened
with 01 . In the incisal area additional effects can be obtained with opaques O2 and O3 .
GA_Biodent K+B Plus OVS II_70014_0418.indd 17
30 ml, 100 ml
30 ml, 100 ml
25 ml, 80 ml
30 ml
5 g, 15 g, 50 g
10 ml
10 ml, 100 ml
17
13.07.18 13:48