Preparing The Connection To The Flue; Installing And Connecting; Use; First Use - Dovre BOW Installation Et Mode D'emploi

Depending on your version:
1. Remove the stove from the pallet (4) by removing
the bolts (1) and washer (3) along the top.
2. Remove the stove from the pallet (4) by removing
the bolts (2) and washer (3) along the bottom of the
pallet.
Preparing the connection to
the flue
When connecting the appliance to the chimney, only a
connection via the upper side of the appliance can be
made.

Installing and connecting

1. Position the appliance in the correct place, and
make sure it is level.
2. Connect the appliance to the flue hermetically.
10
3
2
4
09-20021-187
3
2
4
09-20021-188
3. Re-position all removed parts in the correct places
in the appliance.
Never use the appliance without the fire-res-
istant inner plates.
The appliance is now ready for use.

Use

First use

When you use the appliance for the first time, make
an intense fire and keep it going for a good few hours.
This will cure the heat-resistant paint finish. This may
result in some smoke and odours. You could open win-
dows and doors for a while in the area in which the
appliance is located.

Fuel

This appliance is only suitable for burning natural
wood, namely sawn and chopped wood that is suf-
ficiently dry.
Do not use other fuels, as they can cause serious
damage to the appliance.
The following fuels may not be used as they pollute
the environment, and because they heavily pollute the
appliance and flue, which may lead to a chimney fire:
Treated wood, such as scrap wood, painted wood,
impregnated wood, preserved wood, plywood and
chipboard.
Plastics, scrap paper and domestic waste.
Wood
Hardwood, such as oak, beech, birch and fruit tree
wood is the ideal fuel for your stove. This type of
wood burns slowly with calm flames. Softwood
contains more resins, burns faster and sparks
more.
Use seasoned wood that contains no more than
20% moisture. The wood should have been
seasoned for at least 2 years. Wood with a mois-
ture content of 20% provides 4.2 kWh per kg wood.
Wood with a moisture content of 15% provides 4.4
kWh per kg wood. Freshly felled wood has a mois-
ture content of 60% and only provides 1.6 kWh per
kg wood.
Subject to change because of technical improvements