Log Placement - Napoleon B30NTR Instructions D'installation Et D'utilisation

42
6.2

LOG PLACEMENT

EN
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
TM logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that is
PHAZER
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
Place the rear log (W135-0575) fi rmly onto
A.
the two studs at the rear of the support tray.
Ensure the log sits fl at and does not cover
the pilot opening. Place two pins in the holes
located on the top rear of the rear log.
Position the right log (W135-0577) onto the
C.
two studs located on the right side of the log
support. Place one pin into the hole located
on the top of the right log.
W415-1397 / 09.30.14
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
PINS
A
PIN
A
C
B
WARNING
!
Place the left log (W135-0576) onto the two
B.
studs located on the left side of the log support.
Place the left crossover log (W135-0578) onto
D.
the pin located in the left side of the rear log,
allow it to rest in the notch of the left log.
76.1A
A
B
D
A
B C