Proxxon OZI/E Manuel page 11

For optimal grinding, apply requisite uniform
speed. Applying excessive pressure does not
achieve improved grinding results and increases
heat build-up.
In the event that machine overheats, switch it off
immediately and allow to cool.
Maintenance, cleaning and care
Attention:
Disconnect the mains plug prior to every
adjustment, maintenance measure or repair!
Note:
Every device is dirtied by dust when working with
wood. Cleaning is therefore essential. To ensure a
long service life, however, the machine should be
cleaned with a soft cloth or brush after each use.
Mild soap or other suitable cleaning agent may be
used in this context. Solvents or cleaning agents
containing alcohol (e.g. petrol, cleaning alcohols,
etc.) should be avoided, since these can attack
plastic casings.
The apertures required for cooling the motor must
always be kept free of dust and dirt.
Accessories
For more detailed information on accessories,
please request our device catalogue from the
address specified on the last page in the warranty
information.
Please note in general:
PROXXON bits and cutters have been designed to
work with our machines, which makes them opti-
mal for their use.
We will not assume any liability whatsoever for the
safe and proper function of our devices when using
third-party bits and cutters!
- 10 -
Note:
Note:
Service note
Please note: The mains power input may only be
replaced by our PROXXON Service Department or a
qualified specialist!
Disposal:
Please do not dispose of the device in domestic
waste! The device contains valuable substances
that can be recycled. If you have any questions
about this, please contact your local waste man-
agement enterprise or other corresponding munic-
ipal facilities.
EC Declaration of Conformity
Name and address:
Product designation:
Article No.:
In sole responsibility, we declare that this prod-
uct conforms to the following directives and nor-
mative documents:
EU EMC Directive 2014/30/EC
EN 55014-1:2017/A11:2020
EN 55014-2:2015
EN 61000-3-2: 2019
EN 61000-3-3: 2013/A1:2019
EU Machinery Directive 2006/42/EC
EN 60745-1:2009/A11:2010
EN 60745-2-3:2011
Date: 31.07.2020
Dipl.-Ing. Jörg Wagner
PROXXON S.A., Machine Safety Department
The CE document authorized agent is identical
with the signatory.
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
OZI/E
28520