Use; Installation; Before Use - LIVARNO LUX HG00092A Instructions De Montage, D'utilisation Et Consignes De Sécurité

When inserting the battery ensure the correct polarity! This is
indicated in the battery compartment.
Only use the same type of batteries.
Remove batteries from the device after extended periods of non-use.
Promptly remove drained batteries from the product. There is an in-
creased risk of leaks!
Avoid extreme conditions and temperatures which may impact batter-
ies, e.g on radiators. Otherwise there is an increased risk of leaking.
Failure to follow safety instructions may drain batteries beyond their
end voltage. This will then pose a risk of leaking.
If the batteries have leaked inside the product, please remove them
immediately to prevent product damage!
Batteries do not belong in household refuse!
The law requires every consumer to properly dispose of batteries.

Use

Installation

Secure the mounting plate
screws or adhesive pads
6
respectively.
Place the eyes on the bottom part of the LED light
ing plate and latch in the LED light, sliding it sideways as illustrated
in Figure E.

Before use

The batteries
5
18 GB/IE
7
are factory installed.
to a level wooden surface using the
included. Refer to figures C or D,
8
onto the mount-
1