Erreka VIVO-M203 Guide Rapide D'installation Et Programmation page 13

Number of operators selection (C0); in swing gates only (C301)
P241A
P241E
Changing and checking turning direction for operator A1 and A2 (C1)

This operation is only necessary if operator A1-A2 closes the leaf instead of opening it when resetting (rS).

In step 4 , check turning direction using ST1 (open) and ST2 (close). Use C1 to activate operator 1 and C2 to
activate operator 2.
Changing and checking turning direction for operator A1 and A2 (C2)

A1 and A2 work simultaneously, both C1 and C2 change the turning direction of the two operators at
the same time. The turning direction of a single operator cannot be changed.
P1 Total opening radio code programming (with RSD receiver only, C801)

If a receiver other than RSD is used, see the corresponding instructions.

Before starting programming, select the option C801 (RSD receiver).
P2 Pedestrian opening radio code programming (with RSD receiver only)

This procedure is the same as for total opening, but using parameter P2 P1.
P241B
7
P241F
R141F
P241C
P241G
ST1
P241D
P241H
ST2
R241D
13