Erreka VIVO-M203 Guide Rapide D'installation Et Programmation page 11

DL7: LED SNG1
(encoder) E1
DL8: LED SNG2
(encoder) E1
DL19: LED SNG1
(FCA/ATS) E2
DL20: LED SNG2
(FCC/NA) E2
ST1: open
ST2: close
Operator connection
Single encoder
connection (C701)
E1 connector:
V+: red cable
GND: white cable
SGN1: green or blue
cable
SGN2: do not connect SGN2: closing (FCC)

In sliding (C302) and up-and-over doors (C303), it is only possible to use a single motor (M1),
which should be connected to the "MOTOR 1" terminals.
When using a single encoder (C701, C704) or dual encoder (C703), always connect to the
"ENCODER 1" terminals.
When using limit switches (C702, C704 or C705), always connect to the "ENCODER 2" terminals.
Operator cabling for sliding and up-and-over doors
(parameters C302 and C303)
Limit switch
connection (C702)
E2 connector: E1 connector:
V+: do not connect V+:
GND: common (COM) GND: white cable
SGN1: opening (FCA) SGN1: green or blue
SGN2: purple cable
E2 connector:
V+:
GND: common (COM)
SGN1: ATS operator safety micro and NA
SGN2: bridge to GND
Dual encoder
FC and single encoder connection (C704)
connection (C703)
E1 connector:
red cable V+:
GND: white cable
SGN1: green or blue
cable
SGN2: do not connect SGN2: closing (FCC)
G1/G4: open
G2/G5: close
G3/G6: common
DL4: LED relay M1
DL5: LED relay M2
DL17: LED triac M1
DL18: LED triac M2
A1: Operator 1
E1: "ENCODER 1" terminals
E2: "ENCODER 2" terminals
ATLAS connection (ATS) G6xxI (C705)
do not connect
closing micro (parallel connection)
E2 connector:
red cable V+:
GND: common (COM)
SGN1: opening (FCA)
cable
do not connect
11