Erreka VIVO-M203 Guide Rapide D'installation Et Programmation page 10

DL4: LED relay M1
DL5: LED relay M2
DL17: LED triac M1
DL18: LED triac M2
ST1: open
ST2: close
DL7: LED SNG1 (FCA/encoder) A1
DL8: LED SNG2 (FCC/encoder) A1
DL19: LED SNG1 (FCA/encoder) A2
DL20: LED SNG2 (FCC/encoder) A2
Operator connection
Single encoder
connection (C701)
V+: red cable
GND: mesh
SGN1: green or blue
cable
SGN2: do not connect
10
Operator cabling for swing gates
with single or dual leaf (parameter C301)
Limit switch connection
(C702)
V+: do not connect
GND: common (COM)
SGN1: opening (FCA)
SGN2: closing (FCC)

The C704 option is not available for swing gate operators. if C704 is
selected, it will operate as C701.

The colour of the G1/G4 and G2/G5 cables must be respected in
order to correctly programme the turning directions, i.e., the colour
of G1 must be the same as for G4 (and G2 the same as G5).
Dual encoder connection
(C703)
V+: red cable
GND: mesh
SGN1: green or blue
cable
SGN2: white cable
A1: Operator 1
A2: Operator 2
Vulcan connection
VUS (C705)
V+: do not connect
GND: common (COM)
SGN1: VUS operator safety
micro
SGN2: electrolock micro
(A1 connector only)
G1/G4: open
G2/G5: close
G3/G6: common