Dustbane Micro-5 Manuel D'opération page 8

Unpacking
! WARNING: When unpacking the machine, the operator must be provided with the necessary personal protection devices (gloves,
goggles, etc.) to limit the risk of accident.
Proceed as follows to unpack the machine:
• Cut and remove the plastic straps using scissors or nippers.
• Remove the cardboard packaging.
• Remove the following items from the packaging:
operating and maintenance manual, declaration of conformity, certificate of warranty; battery charger manual;bumper
wheel; front squeegee: brush; battery charger
• Lift the machine out of the box by the handle (fig. 2, ref. 1) and set it down on the floor.
• Pull the handle up at right angles to the machine, referring to the section "Adjusting the handle rake angle"
• Remove the dirty water tank and the detergent tank and set them on the floor, referring to the section "Emptying the
water/detergent tank" and "Emptying the dirty water tank".
• Tilt the machine backwards and rest the handle on the floor.
• Cut the ties applied to the rear squeegee.
• Install the front squeegee (fig. 2A, ref. 1).
• Install the bumper wheel (fig. 2B, ref. 1).
Transport on wheels
The machine can be moved from one place to another on its wheels and steered in all directions:
• Set the angle of the handle so that it stands perpendicular to the machine.
Tilt the machine backwards (fig. 7), and it can be wheeled backwards or forwards as required. Delivery checks On taking
delivery of the machine, check carefully that the packing and machine it contains are both intact.
Adjusting the handle rake angle
Pull the adjustment lever (fig. 9, ref. 1) and hold, then set the handle at the desired angle. Releasing the lever, the handle will
remain locked in the position selected.
8
Operations Manual Micro-5