Dustbane Micro-5 Manuel D'opération page 13

Installation of dirty water tank lid
INFORMATION: INCORRECT positioning of the lid on the dirty water
tank will cause the machine to malfunction when the floor is being
dried.!
• Place the lid on the tank.
• Apply downward pressure to the lid, sufficient to make
certain that the two sliding release catches spring
outwards and engage with the top of the dirty water tank
(Fig.20).
INFORMATION: The lid is correctly installed when the RED background
presented by the recesses of the two catches can NOT be seen (fig. 20).
Filling the water/detergent tank
! INFORMATION: Remember to empty the dirty water tank every time the clean water and detergent tank is filled.
The tank can be filled in two different ways:
Tank installed on the machine:
• Turn off the machine at the main switch.
• Remove the cap of the detergent tank (fig.21, ref. 1).
• Fill the tank.
Tank removed from the machine:
• Turn off the machine off at the main switch.
• Press in the two lateral tank retaining catches (fig. 22, ref. 1),
separate the dirty water tank from the frame and set it down on the floor.
• Remove the cap of the detergent tank.
• Separate the detergent tank from the frame.
• Fill the tank (fig. 23).
Emptying the water/detergent tank
The tank can be emptied by proceeding as follows:
• Turn off the machine off at the main switch.
• Take the machine to the designated disposal area.
• Press in the two lateral tank retaining catches (fig. 22, ref. 1), separate the dirty water tank
from the frame and set it down on the floor.
• Separate the detergent tank from the frame.
• Remove the cap of the detergent tank.
• Empty the contents of the tank by way of the front opening
(fig. 24).
Operations Manual Micro-5
13