Publicité
Les langues disponibles
Les langues disponibles
Working
• Press the main switch (fig. 16, ref. 1).
• Press the brush button or the ECO button (fig. 17, ref. 1), in addition to activating the brush, this
will also enable the vacuum function and the flow of detergent solution.
• Lower the squeegee by operating the lever (fig. 16, ref. 2).
• Depress the brush control lever (fig. 16, ref. 3).
• Begin working.
! INFORMATION: This machine can dry the floor moving both forward and in reverse.
To operate the drying function in reverse, pull the lever upwards (fig. 18, ref. 1)
• When work is in progress, check the thoroughness of the wash and regulate the flow of
detergent solution accordingly, with the relative button (fig. 17, ref. 3).
! INFORMATION: Check periodically that the detergent solution is reaching the brush, and take care to fill the
tank when empty.
! WARNING: Should the red Led of the battery charge indicator light up when work is in progress, this
means that the battery is almost out of power, and after a few seconds the brush and vacuum functions
will shut off automatically. Proceed to recharge the battery, referring to the section "Battery: preparation /
installation / recharging".
In cases where floors are soiled with particularly stubborn dirt, scrubbing and drying operations can be performed in two separate
stages. Prewashing with brushes or pads:
• Raise the squeegee by operating the lever (fig. 16, ref. 2).
• Press the main switch (fig. 16, ref. 1).
• Press the brush control button (fig. 17, ref. 1).
• Switch off the vacuum function by pressing the suction control button (fig. 17, ref. 2).
• Depress the brush control lever (fig. 16, ref. 3).
• When scrubbing particularly dirty areas, give the detergent sufficient time to perform its chemical action of detaching
and suspending the dirt in the film of water, and allow the brushes time to exert an effective mechanical action.
Drying
• Lower the squeegee by operating the lever (fig. 16, ref. 2).
• Press the suction control button to activate the vacuum function, and pass over the area washed previously: this will
produce an effect similar to a thorough scrub, with the result that subsequent routine maintenance work on the floor will
be less time-consuming.
Removal of dirty water tank lid
• Release the lid of the dirty water tank by pressing the two sliding catches toward one
another (fig. 19, ref. 1).
• Lift off the lid.
12
Operations Manual
Micro-5
Publicité
