Dustbane Micro-5 Manuel D'opération page 15

MAINTENANCE INSTRUCTIONS
! DANGER: Never perform any maintenance operations on the machine without first removing the battery pack (battery
poweredmodels).
! WARNING: Before proceeding with any maintenance operation on the machine, always be sure to empty the detergent tank and the
dirty water tank, referring to the relative sections "Emptying the water/detergent tank" and "Emptying the dirty water tank".
! INFORMATION: Maintenance operations involving the electrical system, and in any event all servicing or repair operations not explicitly
described in this manual, must be entrusted to a specialist technician approved by Dustbane or carried out at an Dustbane service centre,
inaccordance with current safety regulations. Ensure the machine undergoes regular maintenance, so
that it will always deliver optimum performance. Do not clean seals with ethyl alcohol.
Maintenance – General rules
When cleaning the machine, observe the following precautions.
• Avoid the use of high pressure washers. Water could penetrate the electrical compartment
or the motors, leading to damage or the risk of short circuit.
• Do not use steam, as the heat generated could cause plastic parts to lose their shape.
• Do not use solvents or hydrocarbon based products. These can damage the cowling and
rubber components.
Cleaning the suction float
• Release the lid of the dirty water tank.
• Turn the lid over and check that the floats can move freely (fig. 29, ref. 1).
• Clean the seals with a moist cloth (fig. 29, ref. 2).
• Refit the lid.
Cleaning the water/detergent tank filter
• Remove the dirty water tank and the detergent tank and set them on the floor,
referring to the section "Emptying the water/detergent tank" and "Emptying the dirty water
tank".
• Remove the filter and wash with water (fig. 30, ref. 1).
Cleaning the suction filter
• Remove the dirty water tank from the machine and set it on the floor, referring to the
section "Emptying the dirty water tank".
• Remove the filter and wash with water (fig. 30, ref. 2).
Cleaning the front squeegee suction hose
• Remove the dirty water tank and the detergent tank and set them on the floor,
referring to the section "Emptying the water/detergent tank" and
"Emptying the dirty water tank".
• Detach the hose from the diverter valve (fig. 31, ref. 1) and from the front squeegee
(fig. 29, ref. 2).
• Wash the hose by directing water into the bore (fig. 32)
• Reattach the hose.
Operations Manual Micro-5
15