Dustbane Micro-5 Manuel D'opération page 19

Troubleshooting
Problem
Machine not working.
Brush not rotating.
Brush motor not starting easily.
Machine not scrubbing uniformly.
Detergent solution not reaching brush.
Suction motor not working.
Squeegee not cleaning or vacuum weak.
Battery not giving expected operational
endurance.
Display Alarms
Alarm
Brush motor thermal overload.
Brush motor overcurrent/short circuit
Detergent pump overcurrent/short
circuit.
Suction motor overcurrent/short circuit.
Excess battery voltage.
Cause
Battery low or flat.
Plug disconnected.
Main switch not activated.
Brush control button not depressed.
Brush control lever not activated. [
Machine is working with a dry brush on a
particularly rough floor.
Brush or pad worn.
Detergent tank empty
Water/detergent tank filter dirty.
Blockage in hose delivering detergent
solution to brush.
Suction control button not depressed.
Lip of rubber blades in contactwith the
floor has become worn.
Float controlled shut-off has been
tripped (dirty water tank full).
Blockage in squeegee suction hose.
Suction hose either not connectedto
squeegee, or damaged.
Diverter valve dirty.
Battery charger not working.
Error indicator
Red Led light on brush control button, 1
slow blink
Red Led alight on brush control button, 1
fast blink.
Red Led alight on brush control button, 2
fast blinks.
Red Led alight on suction control button,
1 fast blink.
Green battery charge Led blinking.
Remedy
Recharge battery
Connect plug to mains socket
Press main switch.
Press brush control button.
Operate brush control lever.
Increase the quantity of detergent.
Replace brush.
Fill detergent tank.
Clean filter.
Remove blockage.
Press suction control button.
Replace squeegee blade.
Empty out dirty water tank.
Remove blockage.
Connect or repair suction hose.
Clean diverter valve.
Replace battery charger.
What to do
Switch off all functions of the machine.
Remove the dirty water tank to let more
air into the motor housing. Wait a few
minutes, then restart the machine If
the problem persists, contact customer
service.
Switch off all functions of the machine.
Restart the machine. If the alarm appears
again, make certain that the brush is not
being used on a particularly rough floor.
If the problem persists, contact customer
service.
Switch off all functions of the machine.
Restart the machine. If the problem
persists, contact customer service.
Switch off all functions of the machine.
Restart the machine. If the problem
persists, contact customer service.
Check the integrity, operation and use
of the battery charger supplied with the
machine.
Operations Manual
19
Micro-5